GAIN STRUCTURE:
Gain structure switch provides three choices of overall gain of the BE-100.
SAT SWITCH:
Primarily designed to add gain, compression and saturation. This is a heavier tone. It is
normal for the volume level to drop with this switch engaged. Compensate with the amp’s Master
volumes.
FOOTSWITCH JACK:
This is where you plug in the footswitch.
EFFECTS LOOP SWITCH:
This engages the series FX LOOP.
SEND JACK:
This is where you plug the INPUT of your Effect(s). Use a high quality shielded guitar cable.
RETURN JACK:
This is where you plug the OUT of your Effect(s). Use a high quality shielded guitar cable.
RETURN LEVEL:
When the FX LOOP is engaged, this controls the overall volume of your amp. Set at 8 to
start.
SPEAKER OUT JACKS (2):
Plug speaker cabinets here. Set Impedance selector to appropriate position.
POWER:
This switches between 50 and 25 watts.
MAINS INPUT:
Plug the supplied IEC power cord here and into a 115v wall outlet to power the beast.
MAIN FUSE:
This fuse is in the compartment found below the AC receptacle. Replace only with type
indicated on rear panel. This is also most likely the result of a bad tube. Constant blowing of this fuse
(even when using new tubes) is an indication that something could be seriously wrong with your amp.
STOP and call us so we may help you diagnose.
POWER SWITCH
: Turn this ON for about one minute before taking the amp out of Standby for maximum
tube life. ALWAYS MAKE SURE THERE IS A SPEAKER LOAD CONNECTED TO YOUR AMP BEFORE TURNING
On.
HT FUSE:
Only replace with Type indicated on rear panel. If this blows, it’s most likely a bad power tube.
Summary of Contents for BE-50 deluxe
Page 1: ...INSTRUCTION MANUAL...
