Friedman BE-50 deluxe Instruction Manual Download Page 5

 

STANDBY SWITCH: 

 This will put your amp into PLAY mode. 

 

POWER INDICATOR LAMP:  

This is a gentle reminder that your amp is powered up. 

 

THUMP CONTROL:  

Adjusts the low-end response in the power section. This is global on all channels.  

Start at about 4-5 and adjust to taste.

  

 

RESPONSE CONTROL:  

Adjusts the overall negative feedback of the power section.  This is global on all 

channels.  Up is brighter and punchier, down is darker, smooth and softer. Start at about 2-3 and adjust 

to taste.

  

 

PRESENCE CONTROL:  

Adjusts the upper mids and highs in the power amp section. This is global on all 

channels.  Start at about 4-5 and adjust to taste.

  

Note:

  THIS POT WILL BE SCRATCHY—THIS IS NORMAL 

 

MASTER CONTROL 2:  

This HBE VOLUME.   

 

MASTER CONTROL 1:  

This is the BE VOLUME.   

 

TREBLE CONTROL:  

This adds or takes away treble.  Start at 5 and adjust to taste.  

 

MIDDLE CONTROL:  

Adds or takes away midrange.  Start at 4 or 5, lower settings will scoop the mids, 

higher levels will allow your audience to actually hear the guitar in the mix.  

 

BASS CONTROL:  

This adds or takes away bass or bottom end.   As the amp gets louder you may want to 

back this off a bit.  Start at 7-10 for bedroom volumes.  

 

GAIN CONTROL 2: 

This adds gain/distortion for the HBE channel. Adjust to taste.  Don’t be afraid

 

 

GAIN CONTROL 1: 

This adds gain/distortion for the BE channel.  Adjust to taste.  Don’t be afraid. 

 

CLEAN VOLUME: 

Adjusts the clean channel’s volume. 

 

TREBLE CONTROL:

  Adjusts the treble on the clean channel.  Start at 5 and adjust to taste. 

 

MIDDLE CONTROL:  

Adds or takes away midrange.  Start at 5 or 6 and adjust to taste. 

 

BASS CONTROL:  

Adjusts the bass on the clean channel.  Start at 5 and adjust to taste. 

 

VOICE SWITCH: 

This tailors the top end response of the amplifier. 3-way switch, center is brightest. 

 

FAT SWITCH: 

 Like it says, makes the BE100 sound fatter.  Great for single coil pickup. 

CHANNEL SELECTOR SWITCH: 

Switches between Clean, BE and HBE channels when Footswitch is not 

connected. 

 

BRIGHT SWITCH: 

3 position switch that varies the overall brightness of the Clean Channel ONLY. 

 

       INPUT:

  Just like it says. This is the BE100’s Guitar Input Jack. 

 

 

Summary of Contents for BE-50 deluxe









Reviews: