140.010-IOM (NOV 2019)
Page 20
IDSC EVAPORATIVE CONDENSERS
INSTALLATION
Figure 38: Louvers and supports
INSTALLING INLET LOUVERS
1. Pick up the inlet louver by holding the louver pattern.
2.
Angle the inlet louver to place the top end into the
inlet louver space and slide it all the way up under the
squared inlet louver front supports.
Figure 39: Angling the louver
3.
While the inlet louver is slid as far up as it can go into
the inlet louver opening, put the bottom of the inlet
louver into place.
4.
Set the inlet louver down so that it rests in the bottom
of the inlet louver opening.
Figure 40: Setting the louver
REMOVING INLET LOUVERS
1. Grab the inlet louver pattern.
2.
Slide the inlet louver straight up to release the bottom
of the inlet louver from the inlet louver opening.
Figure 41: Detaching the louver
3.
Pull the bottom of the inlet louver out to remove it.
4. Slide the inlet louver down to release the top of the
inlet louver from the inlet louver front supports.
Figure 42: Removing the louver
