27
Factory reset procedure from the remote control
(RESET)
Status of the LEDs of the regulator Green LED = Working
Orange LED = Awaiting for synchonization or communication
Red LED = Air conditioner stopped
Red RED flashing = error
!
Be careful before this step make sure that all electrical elements,
wires, probes etc. are properly connected. Without this, the functions
of the probes and the motors would not be taken into account.
Ré-Appairer le régulateur avec la télécommande
Réglages
Manipulations
A
ffichages
Remarques
Pair the control
-
ler with the
remote control
Push on
about 6s
until the appearance
OK
Press on
to pair the card
-The 3 LEDs light up
-The red LED is fixed
after a few seconds
The green and orange
LEDs light up
The red LED becomes
fixed. The screen displays
OFF and turns off. Pairing
is complete.
Remove the black
protection cap from
the pairing button
Using the tool provi
-
ded, gently press the
button for 5 sec. then
release
Turn on the power
Genesis-Vintage
MPCG Re-pairing / Reset controller
MPCG
One-piece rear sight
One-piece front sight
One-piece front sight
- If the monobloc is
equipped with a ducted
facade on the evaporator
side, it must be dismant
-
led beforehand.
-The message INIT rF
flashes.
The reset will change the parameters to their factory value
Set the fan speed, temperature and humidity
Restart the unit
With the remote
Press .
For 2 seconds
Unit starts
If symbol or
flashes, unit is
in stand by mode
Press
until or
become fixed
Press simultaneously
OK
Push
+
10 Seconds
