Fri-Jado TDR 7 p Gas, User Manual

Page: 13 / 48

TDR-P
eco
Gas
EN 13 / 48
WARNING
Electric chock hazard . Grounding instructions: only connect the appliance to an
alternating current provided by a grounded wall socket, with a mains voltage in
accordance with the information indicated on the data plate of the appliance.
It is the consumer's responsibility to make sure the electrical installation conforms
with current national and local codes and wiring regulations.
Do not use a multi plug or extension cord. Such can result in fire, electrical shock,
or other personal injury.
Failure to follow these instructions can result in death or serious injury.
•
The user must have sufficient freedom of movement to properly operate the unit
•
The minimum free distance to combustibles and Non-combustibles must be at least 100
mm (4 inch).
•
During grilling, the glass panes will get very hot. While positioning, keep the unit out of
children’s reach.
•
The gas connection has an outside diameter of ½ inch. The gas connection must be
mounted by a registered installer.
•
The oven must be installed so that the flow of combustion and ventilation air will not be
obstructed. Make sure there is an adequate supply of air in the room to allow for that
required combustion of gas of the oven chamber.
•
Keep the space around the bottom and the ventilation opening in the top of the TDR free
from obstacles to guarantee a good air flow in the electrical compartment and combustion
chamber.
•
The unit has a mains plug, and must be connected to a wall socket with the proper mains
voltage. The wall socket must be mounted by a certified electrician.
•
Appliance is for use only with the specific legs or casters specified by the manufacturer.
•
In case of a wheeled unit, the floor must be flat and leveled.
•
North American units must be installed conform local codes, or in the absence of local
codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA 54, or the Natural Gas and
Propane Installation Code, CSA B149.1, as applicable, including:
i) The appliance and its individual shutoff valve must be disconnected from the gas supply
piping system during any pressure testing of that system at test pressures in excess of ½
psi (3.5 kPa).
ii) The appliance must be isolated from the gas supply piping system by closing its
individual manual shutoff valve during any pressure testing of the gas supply piping system
at test pressures equal to or less than ½ psi (3.5 kPa).