P
a
g
e
| 8 of 20
FREMCO A/S
ELLEHAMMERVEJ 14
|
DK9900 FREDERIKSHAVN, DENMARK
|
VAT NO.: DK30815416
TEL45 7230 1213
|
|
WWW.FREMCO.DK
Machine service is required annually or every
350 km depending on what comes first.
6. IDENTIFICATION
These instructions have been made to support the
users of the fiber blowing machine NanoFlow
MAX. The machine type can be identified by the
type plate on the machine. The type plate provides
information about serial number, year of
production and name and address of the
manufacturer.
It is recommended to read this instruction
carefully and become familiar with the
functionality and maintenance of the fiber
blowing machine before use.
7.
APPLICATION
The fiber blowing machine NanoFlow MAX is
constructed for blowing fiber into microducts
within the FTTH segment.
We do not recommend use for other applications.
Always use adaptor plates designed for the actual
diameter of fiber and duct. The adaptor plates are
marked with the size for which they are intended.
It is very important to use the correct adaptor
plates. If the adaptor plates do not fit the duct,
dangerous situations may occur.
The machine comes in a carrying case. When the
machine is not in use or during transportation,
always store it in the carrying case.
Charge the battery before operation.
8. MOUNTING
Make sure to place the machine on a stable
foundation before blowing.
Alternatively, place the NanoFlow MAX on the
tripod or in the shoulder strap, depending on the
working situation. Please see the section on
Accessories on page 11 for further information.
9. SUPPLY OF
COMPRESSED AIR
The volume and quality of compressed air is one of
the most important parameters in order to achieve
good results when blowing fiber. The amount of air
needed depends on fiber size, duct size and
blowing distance. A capacity less than 200 l/min. is
not recommend for long blowing distances.
The compressed air must be filtered, cooled and
dried to avoid moisture and dirt in the microduct.
WARNING
: Do not use compressed air
directly from a compressor unit, since the
air can be very hot and can damage
microduct, fiber and machinery.
For short blowing distances, the NanoFlow MAX
can be used without supply of air.
NB: To maintain your 36-months warranty, you
have to meet the given service requirements.
NB: The machine is intended for indoor use and
not for use in wet environments, i.e. rainy weather.
If the machine is exposed to rain or humidity, it
can result in malfunction of the machine and lapse
of warranty.
