LRS455 Wireless Data Transceiver
Quick Start Guide
QSG0016AA Rev B
4
6. Press
3
in the Main menu.
•
Set the following parameters so they are the same on all radios in the network:
o
FreqKey
(Tx Frequency and Rx Frequency)
o
Max Packet Size
o
Min Packet Size
o
RF Data Rate
(Only
RF Data Rate 4
and
5
are approved by the FCC for use in the
United States.)
The
Tx Frequency
and
Rx Frequency
options, or Frequency Key, are located in the F
submenu after you press
0
to access the Frequency Key menu in Main menu
3
.
Changing these values from the factory defaults may help to eliminate interference from other
networks.
•
Press
Esc
to return to the Main menu.
7. Press
Esc
to return to the Main menu.
8. Press
5
in the Main menu.
•
Set the
Network ID
value to any value between
1
and
4095
, except
255
. FreeWave
recommends setting the
Network ID
to the last three or four digits of the radio’s serial
number, as this is a number you can look up if necessary.
•
Ensure this value is the same on every radio in the network.
9. Press
Esc
to exit the Setup menu and resume normal radio operation.
Point-to-MultiPoint Operation LEDs
Master
Slave
Condition
Carrier Detect
(CD)
Transmit
(TX)
Clear to
Send (CTS)
Carrier
Detect
(CD)
Transmit
(TX)
Clear to
Send
(CTS)
Powered, not linked
Solid red
bright
Solid red
dim
Off
Solid red
bright
Off
Blinking
red
Slave linked to Master,
no data
Solid red
bright
Solid red
dim
Off
Solid
green
Off
* Solid red
bright
Slave linked to Master,
Master sending data to
Slave
Solid red
bright
Solid red
dim
Off
Solid
green
Off
* Solid red
bright
Slave linked to Master,
Slave sending data to
Master
Solid green
RCV data
or Solid red
bright
Solid red
dim
Intermittent
flash
red
o
Solid
green
Intermittent
flash
red
o
* Solid red
bright
Master with diagnostics
program running
Solid red
bright
Solid red
dim
Intermittent
flash
red
o
Solid
green
Intermittent
flash
red
o
* Solid red
bright
* Clear to Send LED is solid red
with a solid link, as the link weakens the Clear to Send LED light on the
Slave begins to flash
.
