51
H
Password
H
Hot KEY
H
Mouse Left
H
Mouse Right
H
Any KEY
KB Power ON Password: This field becomes available when you select
“Password” in the POWER ON Function field. Select this field and press
ENTER. You are prompted to input a password. Type in your password
and press ENTER. You are prompted to confirm your password. Retype
your password and press ENTER. Your password is saved. The next time
you power on your computer, you must type in your password before you
can power the computer on. After you type your password, press any key
or the power button.
Hot Key Power ON: This field becomes available when you select “Hot
Key” in the POWER ON Function field. Options for this field are “Ctrl-
F1” ~ ”Ctrl-F12.”
Onboard FDC Controller: This option enables the onboard floppy disk
drive controller. The default setting is “Enabled.”
Onboard Serial Port 1/2: These options are used to assign the I/O
addresses for the two onboard serial ports. They can be assigned as
follows:
H
3F8/ IRQ4 (Port 1 default)
H
2F8/ IRQ3 (Port 2 default)
H
3E8/ IRQ4
H
2E8/ IRQ3
H
Auto
H
Disabled (disables the onboard serial port)
UART Mode Select: Enables you to select the infrared communication
protocol-Normal (default), IrDA, or ASKIR. IrDA is Hewlett Packard’s
infrared communication protocol with a maximum baud rate up to 115.2K
bps. ASKIR is Sharp’s infrared communication protocol with a maximum
baud rate up to 57.6K bps.
Integrated Peripherals
BIOS Configuration
