16
P5F111 User’s Manual
Connector
Description
IDE1, IDE2
Primary IDE connector. Connect the single end of
the included IDE cable to this 39-pin connector
block. Connect the other ends of the cable to one
or more hard disk drives. Note that if you install
two hard disk drives with this connector, you must
set the second drive to Slave mode. (For a descrip-
tion of using Master and Slave modes, refer to the
documentation that came with your hard disk
drive.)
(i)
To have two hard disk drives both configured
to Master mode, attach one drive to the IDE1 con-
nector and another to the IDE2 connector.
Front Panel
Connector
Connect these connectors to the appropriate fea-
tures on the front panel: Power LED, internal
speaker, HDD LED, Reset button, and Power
Switch.
Chapter 1: Introduction
