MOTOROLA
DSPD56362EVM Upgrade Manual
2-1
SECTION 2
DEMONSTRATION INSTRUCTIONS
2.1
INTRODUCTION
This section describes the instructions on how to setup the EVM to demonstrate Dolby
Digital
TM
, Dolby Pro Logic
TM
, DTS
TM
and MPEG decoding.
2.2
REQUIRED EQUIPMENT
•
Dolby Digital
TM
, DTS
TM
, or PCM source, i.e. DVD, Laserdisc, DAT, CD, VHS, etc.
•
An audio amplifier driving headphones or speakers as shown on the following page in
Figure 2-1
•
7-9V AC/DC power supply
2.3
DEMONSTRATION SETUP
1. Verify that the DSP, 68HC11, and EPROM have been upgraded as described in
Section 2.3.
2. Verify that the jumper modifications have been made as described in Section 1.3.4.
3. Verify that the jumper settings are correct as shown in Figure 2-2. The default jumper
setting assumes that an optical cable is used to connect the input to the EVM.
However, if using a coaxial cable, move the jumper on JP18 to pins 1-2.
4. Connect the input and output cables to the EVM as shown in Figure 2-1.
5. Apply 7-9V AC/DC to the power connector P2.
F
re
e
sc
a
le
S
e
m
ic
o
n
d
u
c
to
r,
I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
n
c
.
..
