6
2. While another person lifts the rear of the Frame (1),
attach the Rear Stabilizer (16) to the Frame with
four M8 x 50mm Button Screws (52) and four M8
Split Washers (55).
52
16
1
4
2
Avoid pinching the
Wires (43, 51) during
this step
1
4. Have another person hold the Upright (2) near the
front of the Frame (1). Locate the wire tie (see the
inset drawing) in the Upright. Tie the lower end of
the wire tie to the Wire Harness (43) and to the
Pulse Wire (51). Next, pull the upper end of the wire
tie upward out of the top of the Upright. Then, untie
and discard the wire tie.
Tip: Avoid pinching the Wire Harness (43) and
the Pulse Wire (51) during this step.
Attach the
Upright (2) to the Frame (1) with an M10 x 63mm
Bolt Set (62).
2
52
55
55
62
43
62
43
51
51
3
7
1
3. Tighten the Upright Knob (7) into the Frame (1).
Wire Tie
