18
4. Using cable cutters, cut off one inch of the end of
the cable.
IMPORTANT: Other tools may flatten
or bend the cable strands so that it may be dif-
ficult for you to reinsert the cable into the cable
clip.
5. Cut off one inch of the black sheath from the end of
the cable.
6. Reinsert the cable and the sheath into the cable
clip so that all of the bare cable is in the hole.
7. Retighten the four set screws equally until they
contact the cable. Then, tighten each set screw
alternately 1/4 turn, until all are set to 85 inch/
pounds (9.6 Newton-meters).
8. Slide the cable stop onto the cable clip, remove the
weight pin, and lower the handle.
9. Check for proper tension on the cable as described
in CABLE ADJUSTMENT on page 17.