10
6. Set the console assembly on the Upright (93). Be care-
ful not to pinch any wires. Make sure that the ends of
the Console Crossbar (110) are inserted into the ends of
the Upright.
Start two 3/8" x 2 1/2" Bolts (61) with two 3/8" Flat
Washers (78) into the Upright (93) as shown. Do not
tighten the Bolts yet.
Next, attach the console assembly to the Upright (93)
with two 3/8" x 2 1/2" Bolts (61), four 3/8" Star Washers
(66), and two 3/8" Locknuts (87) as shown. Do not fully
tighten the Bolts yet.
93
61
61
66
66
87
87
61
78
6
Console
Assembly
7. Start four 5/16" x 1" Screws (51) into the Upright (93)
and the Console Crossbar (110); start all four Screws,
and then tighten them.
Tighten four #8 x 3/4" Tek Screws (86) into the Upright
(93) and the console assembly.
Tighten the four 3/8" x 2 1/2" Bolts (61). Make sure
that the four #8 x 1" Screws (91) are tightened. Be
careful not to overtighten the Screws.
51
93
86
86
61
61
110
103
7
51
8. Tighten two #8 x 3/4" Screws (86) into the Console Base
(109) and the Upright (93). Do not overtighten the
Screws.
Identify the Left and Right Handrail Assemblies (112,
113). Hold the Right Handrail Assembly (113) near the
Upright (93). Insert the wire from the Right Handrail
through the hole in the Console Base (109) and out of
the top of the Upright.
Apply three drops of the included thread adhesive to the
threaded ends of two 3/8" x 5 1/2" Screws (50). Then,
attach the Right Handrail Assembly (113) to the Upright
with the two Screws and two 3/8" Washers (133). Start
both Screws, and then tighten them. Note: Torque
the Screws to 340 in-lbs.
Attach the Left Handrail Assembly (112) as described
above.
50
50
86
93
112
109
Wire
113
8
Console
Assembly
91
91
110
110
133
133
86
78
61
Wire
