29
HOW TO USE THE MAINTENANCE MODE
The console features a maintenance mode that allows
you to access information and to view and change var-
ious default settings. Follow the steps below to use the
maintenance mode.
1. Insert the key into the console.
See GETTING STARTED on page 16.
2. Hold down the ENTER button and the CLEAR
button simultaneously for two seconds to se-
lect the maintenance mode.
When the maintenance mode is selected, the
words MAINTENANCE MODE will appear in the
main display. The word HOURS and the total num-
ber of hours that the treadmill has been used will
then be shown.
3. Press the ENTER button to view the total dis-
tance that the walking belt has moved.
4. Press the ENTER button again and set a maxi-
mum program time.
To set a maximum program time, press the + and
– buttons beside the ENTER button. The maximum
program time can be up to 90 minutes.
5. Press the ENTER button again and set the
delay time for the timeout mode.
Any time that the treadmill is not used for several
minutes, the console will enter a timeout mode and
the words SELECT PROGRAM TO BEGIN will ap-
pear in the main display. To set the number of sec-
onds before the console will enter the timeout
mode, press the + and – buttons beside the
ENTER button. The delay time can be from 15 to
120 seconds.
6. Press the ENTER button again to create the
CUSTOM programs.
The words CUSTOM PROGRAM will appear in the
main display.
You can design up to three CUSTOM programs.
To select a CUSTOM program, press the + and –
buttons beside the ENTER button. When you see
the CUSTOM program you want to design (PRO-
GRAM 1, PROGRAM 2, or PROGRAM 3), press
the ENTER button.
Note: If the CUSTOM program has not yet been
defined, only two rows of indicators will appear
in the matrix.