INITIALIZATION:
NOTE: The stabilization module needs to sit perfectly still for 5 seconds when initially powered up. The best way for
this to happen reliably is to power the mount with the camera mount transmitter set to the “OFF” position on the mode
switch. This will prevent any of the axes from moving on power up and allow for accurate calibration.
LEDs:
The LEDs give a visual indication of the module’s status as follows:
Orange LED fast blink = Initializing motor drive
Orange LED slow blink: = IMU self-test fault
Green LED quick blink = IMU initializing (keep module perfectly still)
Orange LED solid = S.Bus / Spektrum / PPM / signal valid
Green LED slow blink = Motor drive off (or drive initialization failure)
Both LED solid = Bootloader mode
ANGLE LIMITS:
The stabilization system has programmed software limits of -110° to 10° on the tilt axis and -30° to 30° on the roll axis.
Keep in mind these angles are relative to the ground reference, not the aircraft.
DISABLE CONFIRM:
Checking this box will disable the warning message below:
P40
P39
Summary of Contents for RADIAN
Page 1: ...VER1 0...
