P27
STEP 4: CHANNEL CONFIGURATION
Now the Input / Output configuration must be defined for each module. The preferred installation
is using an S.Bus, Spektrum, or PPM receiver for minimal wiring and clutter; however, PWM
connectivity is also supported.
S.BUS / PPM / SPEKTRUM INSTALLATION
Please note we use S.Bus installation as an example below, but Spektrum and PPM installation would be
similar, with the only difference being using a PPM receiver or Spektrum satellite.
Connect your receiver’s S.Bus connection to the S.Bus input (Port 1) on the pan module. This is the only
connection that the stabilization system will need from the S.Bus receiver. The pan module will pass the
S.Bus signal along to the roll and tilt modules. The modules may now be configured with your preferred
channel assignment for slew, mode, and Aux. The standard Freefly configuration for S.Bus receivers is
below.
NOTE
:
PRIOR TO SETTING THE CHANNEL CONFIGURATIONS, IT IS IMPORTANT TO REVIEW THE
INSTRUCTIONS AND INFORMATION INCLUDED UNDER STEP 5 - PARAMETER CONFIGURATION.
S
LEW CHANNEL: 1
MODE CHANNEL: 5
AUX: 0 (OFF)
PAN MODULE
SLEW CHANNEL: 0
MODE CHANNEL: 5
AUX: 0 (OFF)
ROLL MODULE
P28
Summary of Contents for RADIAN
Page 1: ...VER1 0...
