18
FreedomAlert
®
v3.2-F6
3. When Pendant learning has been successful you will hear “All Systems
are OK” and then it will announce the call setting that the base is set
to – Friends 911 Mode, Friends Only or 911 Only.
• If “Base and Pendant out of Range” or “Pendant Learning Failed” is
heard from the Base or Pendant, STOP - wait 30 seconds and start
at step #1 again.
Notes:
• You have up to 45 seconds after pushing the RED Code Learn button
on the base unit to get the pendant to enter “Pendant Learning” Mode.
• Teaching additional pendants does not erase previously learned pen-
dants.
• The base unit will automatically exit the pendant learning mode after
several seconds or if Pendant Learning Failed.
• If you hear the voice prompt “Base and Pendant Out of Range” or
“Pendant Learning Failed” an error has occurred, wait 30 seconds for
the base to reset and repeat steps 1 & 2.
• When more than 1 pendant is learned to the base, the base unit will
announce the pendant number when when the battery/system test is
performed.
At a later point in time, you might want to erase your previously learned
Pendants. You can erase all previously learned Pendants by simply holding
down the red
Code Learn
button at the back of the Base unit for 8 seconds.
You will hear the confi rmation of “Previous Pendant Codes Erased” from
the Base unit. After that, you can program a new Pendant to the base unit
following the steps above as desired.
Operating the FreedomAlert:
Operating the Pendant.
The Pendant
is simple in operation - having one main
Blue button - and a smaller Gray button
on the back.
The Blue button on the front is the main
button to push for a full 2 seconds to
Front
Back
Blue Button
Gray Button
