freeView Pro C80H User’s Manual
Figure 3-2: Daisy-chaining KVMs
3.5 Turning On the Drawer
1. Make sure all cables and the power cord are connected properly.
2. Be sure to tighten all connector screws on the back of the unit.
3. Flip the power switch on the front of the unit to the “on” position.
4. Ensure that the unit is not locked (the keyhole should be vertical if unlocked).
5. Grasp the handle on the front of the device, pull out slowly and smoothly, and then flip the
device upwards once it has been pulled out completely.
6. This will disengage the soft on/off switch and the unit should power on.
7. If the unit does not power on, press the power button to the left of the LCD screen.
8. The Status LED on the left of the monitor panel should turn from orange to green, verifying
that the unit is operational.
3.6 Increasing the Range of the Monitor
If you would prefer to pull the monitor out further from the rack, you can unlock the unit from the
home position by unscrewing the two screws on either side of the device by turning counter-
15
