Freedom Lite Commercial Installation Manual Revision 3
P a g e
12 | 29
modules are fitted from the front. A minimum of 750mm space in front of the
enclosure is ideal for installing the modules. However, in the case of two of these
models being fitted into a shipping container the centre aisle space is limited to
500mm, which can be accommodated.
Fixing holes are provided at the top and bottom of the rear of the enclosures for fixing the
batteries to a wall or container side to prevent movement after installation. These are
specifically required when a battery is installed into a container that will be transported to
site complete with battery and other equipment.
Note:
All Lite Commercial models can be offered complete ex-factory installed into a
shipping container. Such systems are pre-commissioned at the Freedom Won factory and
can be combined with the required battery inverters supplied and fitted by Freedom Won.
For lifting the factory assembled Commercial units into position specialised equipment is
required. A high-up crane truck or a forklift is required for offloading. For lifting the battery
upright a crane or forklift can be used if there is sufficient height clearance, otherwise a
mobile gantry crane like the one pictured below should be used. These cranes are available
from Freedom Won in three sizes:
1.
Small – for lifting models up to Lite 60/42 (not applicable for Commercial range)
2.
Medium – for lifting models up to the Lite 100/70
3.
Large – for lifting models up to the Lite 140/98
