Free The Tone Arc-53m, Owner'S Manual

Page: 5 / 16

CONTROL PANEL
Display
The numeral shown in the tens place is the bank number and the
numeral shown in the ones place is the number of the preset currently
recalled. When MIDI signals are sent or received, the dot labeled
“
MIDI SIG ” is lit and when Memory Protect function is active, the dot
labeled “ M.PROTECT ” is lit.
100 LED
This LED illuminates to indicate number 100 when the MIDI program
change number or MIDI control change number is over 100. For
example, if the
100 LED illuminates and the Display shows “01”, then
this means No. 101. When the Display shows the bank or preset
number, this LED indicates the tens of the bank number. If, for
example, the
100 LED illuminates and the Display shows “15”, then
this means Bank no. 11, Preset no. 5.
INC/+ and DEC/– switches
Used to change the bank number when in usual mode (Preset mode)
and used to change parameters when in Edit mode.
STORE switch
Used when storing your change to the setting in the preset.
ENTER switch
Used in Edit mode to select the item to be edited or to confirm the
changes you made.
LOCK switch
Used to lock the switches on the control panel, preventing
unintentional tampering. Holding this switch for three seconds locks
the switches and the LED illuminates. Pressing the switch for three
seconds again unlocks the control panel and the
LOCK LED goes
off. Note that the INC/+ and DEC/– switches are not locked in order
to change the bank number.
DISP MODE (Display Mode) switch
Used to change operating modes of the LED displays or Select
Switches.
Effect Loop/Control Terminal LED
Indicates the on/off status of each loop (L1–L5) and each control
terminal (C1–C3). Loops can be turned on/off by pressing the
corresponding Select Switches ( ) 1–8.
Select Switches
Used to edit or confirm the contents saved in presets. Note that the
items to be selected vary according to the mode selected by the
DISP MODE switch.
MIDI CH (PC NUMBER) LED
When the Display is set to MIDI PC & CC# mode, pressing any of
the Select Switches ( ) 1–4 selects the corresponding MIDI send
channel. Select Switches 1–4 correspond to MIDI channels CH1–
CH4 respectively. The LED above the pressed switch illuminates and
the MIDI program change number being sent via the current preset is
shown in the Display ( ).
CSW (CC NUMBER) LED
When the Display is set to MIDI PC & CC# mode, this LED indicates
the on/off status of CSW (control switch) function. CSW (control
switch) can be turned on/off by pressing the corresponding Select
Switches ( ).