TPA600 Rev170623
6
INSTALLATION
The Engine Monitoring Display receives engine RPM, oil pressure, coolant
temperature, and voltage information over the J1939 CAN bus from the engine ECM.
(Refer to Wiring Section.)
Install Display Module
1. Measure and mark mounting location for display module cable and mounting
screw holes. Make sure there is clearance behind the panel for the module and
cables before drilling holes. Refer to Figure 2 for layout and dimensions.
2. Drill a 1.25-inch diameter hole.
3. Drill four holes, clearance or tapped, for 10-32 mounting screws.
3. Place display module in position and secure with screws.
4. Connect cable at rear of the module. (Refer to Wiring section.)
Install Buzzer
A buzzer is supplied with the Engine Monitoring Display. Install the buzzer close to
the control module so the audible warning is easily associated with the visual warning
on the display. A cutout hole of 1-1/8" (1.125") is required on the pump panel. (Refer
to Wiring Section.)
