Franklin Fueling Systems EVO 200, Installation Manual

Page: 14 / 16

10
IMPORTANT: In the following step, your large, white ribbon cable connector may not have the
latches shown. Be extremely careful and gentle when you connect this cable. The connector is
very delicate. If you break it, you must replace the entire main circuit board.
4. Connect the white ribbon cable to the LCD DISPLAY connector.
If there are latches on each side of the connector, make sure they are up when you connect
the ribbon cable. Lock each side of the connector, alternating back and forth until both are
seated properly. Gently tug the ribbon cable after you lock the latches to verify that the
white ribbon cable is locked in place.
Improper seating Proper seating
5. Connect the backlight power cable to the 2-pin BACKLIGHT connector.
6. Insert the new 2-pin stacker display ground (that was included in your LCD display kit) in
the J-18 connector. Make sure you insert it in the holes that are closest to the center of the
main circuit board.