OWNER’S MANUAL
C1-SERIES CISTERN
BEFORE YOU START
BEFORE INSTALLING PUMP, BE SURE TO READ THIS
OWNER’S MANUAL CAREFULLY.
REFER TO PRODUCT DATA PLATE(S) FOR ADDITIONAL
OPERATING INSTRUCTIONS AND SPECIFICATIONS.
•
Keep work area clean, well-lit and uncluttered.
•
Keep safety labels clean and in good condition.
•
Wear safety glasses while installing or performing
maintenance on pump.
•
Adhere to the guidelines of the National Electric Code (NEC)
or Canadian Electric Code (CEC), and any other state and local
codes for ALL electrical installations. Check with the
appropriate agencies or contact a licensed electrician.
•
Most water system problems result from improper installation.
It is suggested that you read this manual carefully
before installing your pump.
•
Check and make available all the tools you will need to
install your pump. Required tooling may include wrenches,
pipe sealant, pipe fittings and nipples, screwdriver, etc.
Be sure to have available proper and adequate wiring material
to complete the installation correctly.
READ AND FOLLOW SAFETY INSTRUCTIONS
This is the safety alert symbol. When you see
this symbol on your pump or in the manual, look
for one of the following signal words and be alert
to the potential for personal injury:
warns about hazards that will cause
serious personal injury, death or major
property damage if ignored.
C AUTION
DANGER
warns about hazards that can cause
serious personal injury, death or major
property damage if ignored.
warns about hazards that will or can
cause minor personal injury or major
property damage if ignored.
The label
NOTICE
indicates special instructions, which are
important but not related to hazards.
Carefully read and follow all safety instructions in this
manual and on pump.
Keep safety labels in good condition.
Replace missing or damaged safety labels.
HAZARDOUS PRESSURE
. Do not run pump
against closed discharge. Release all system
pressure before working on any component.
Under certain conditions, submersible pumps
can develop extremely high pressure. Install
a pressure relief valve, which is capable
of draining the pumps max output at the
relief valves rated pressure.
Do not run pump dry
. Pump must be fully submersed in water
prior to starting. If run without water, the pump and motor will
be damaged.
Electrical
Safety
Make sure all
ELECTRICAL POWER IS OFF
before connecting any electrical wires.
C AUTION
WARNING
WARNING
C AUTION
WARNING
WARNING
Summary of Contents for C1 SERIES
Page 2: ......
