EN
7
7
Fitting the hood body – Ducting Version
Ducting Version Rear outlet
• If the air outlet on the Rear of the hood has been selected, the
Air outlet Reduction-plug
8c
must be screwed into the top
part of the Hood using 2 Screws
12e
provided.
Ducting Version Top outlet
• If the air outlet on the top of the hood has been
selected, the 2 brackets visible in the top part of
the hood canopy must be removed. Also remove
the pre-scored section shown in (Fig.
2
) to allow
the pipe to pass through.
• Screw the brackets to the pre-scored piece, after
removing it as described above, using 2 screws
12e
provided.
• Rest the Hood Canopy
1
on the Suction Unit
3
, inserting it, and fix it at the side using the
2 screws
12b
. (Fig.
1
)
• Screw the pre-scored piece with the
brackets (Fig.
2
) back onto the top part of
the hood canopy, using 2 screws
12e
provided, so as to block the air ducting
pipe.
• If a size 120 pipe is used, break the inner part of the air outlet
Reduction-plug
8c
.
Insert the ring obtained in this way into the air ducting pipe and
screw it to the hood canopy using 2 screws
12e
provided.
fig.2
12e
12e
8c
12e
ø 120
fig.1
12b
