1T 310'783 Operating Manual
Ecolino / Ecopower Milk System
Erstellt: 07.05.2002 Rev.: C SL: 20'987 BJC
page 27
last backup
date 14.04.1997
4. Remove the Download Card from the Chip Card
select product
reader
15:00 10.04.1997
4.3 Adjust Card
The most important settings can be changed or adapted using the Adjust Card:
- Set amount ground
- Set water flow
- Product counter total and per product
- Clear counter
- Set time
- Set data
- Set on/off times
- Change PIN code
4.3.1 Handling of the Adjust Card
If the Adjust Card has not yet been assigned to the Ecolino (setting made at the factory), the user
will be requested to enter the installation number when the Adjust Card is inserted into the chip card
reader for the first time. The installation number can be found on the rating plate under the
identification no. During the input, the Stop key is used for increasing the number and the Clean key
for reaching the next digit position. On subsequent use of the Adjust Card, there is no request for
this input.
1. After insertion of the Adjust Card, the PIN code is scanned depending on the program
pin-code 0000
‘-/+’ ‘shift"
?
2. Digits are entered using the "+" or "-" key. The next position is reached using the Shift key.
3. Once the PIN code has been correctly entered, the user enters the Adjust level.
4. If the PIN code was not correctly entered, the Adjust Card must be removed and reinserted. Input
of
the PIN code can now be repeated starting from point 1.
4.3.1.1 Set amount ground
1. Insert Adjust Card
2. Press the "+" or "-" key until the parameter
adjust millquantity
is obtained
select product
3. Select the product to be changed
adjust millquantity
(For shift products, the Shift key must be pressed
0%
and then the product key)
