Franke ARTH101, Installation And Operating Instructions Manual, Page: 9 / 20

9
18
-05
.6
3
3
b
-G
B.f
m
Install a new coiled-strip spring
☞
Important!
• Grease the bearing bore of the coiled-strip spring and the skids of the slider (i). Use
grease only; do not use oil!
• Carefully note the position in which the coiled-strip spring is mounted. The coiled-
strip spring must roll off along the right-hand side of the guide rail.
• Make sure that the coiled-strip spring moves easily and that the locking nut (f) is
firmly seated.
13.14
Reassemble in the reverse order.
13.15
Pull the guide block all the way down and grease the surfaces of the new coiled-strip
spring.
Mount the height adjuster
☞
Important!
• Before mounting, make sure that the height adjuster moves easily and that the screw
connections are properly tightened.
13.16 Mount the height adjuster (see Chapter 9. ).
13.17 Mount the mounting plate and the hair dryer (see Chapter 10. ).
14. Fault Correction
If you are unable to correct a fault or if the fault is not described in the fault correction section,
please inform our customer service department!
Fault Cause Remedy
Height adjuster
moves stiffly – The screw axle of the coiled-strip spring
has been screwed in too far
➯
Adjust it
– The slider and the guide rails are dirty
➯
Clean and grease
– The coiled-strip spring is dirty
➯
Clean and grease,
replace if necessary
Running noise – The slider and the guide rails are dirty
➯
Clean and grease
– The coiled-strip spring is dirty
➯
Clean and grease,
replace if necessary
– The coiled-strip spring is defective
➯
Replace it
Irregular motion – The slider and the guide rails are dirty
➯
Clean and grease
– The coiled-strip spring is dirty
➯
Clean and grease,
replace if necessary
– The coiled-strip spring is defective
➯
Replace it
Guide block sinks – The coiled-strip spring is fatigued
➯
Replace it
– The coiled-strip spring is defective
➯
Replace it