42
!
25
Inserting the viewfinder mask for the
4.5cm x 6.5cm format
Remove finderhood from camera, unlock focus-
ing-screen frame by withdrawing buttons
6
,
swing up and remove focusing screen. Be care-
ful not to touch its surfaces!
Place camera on its back as shown above. Place
focusing screen with its matte side facing inside
between the edges of the viewfinder mask.
Slide viewfinder mask with focusing screen into
focusing-screen frame. Close focusing-screen
frame until it clicks in place and replace finder-
hood.
Changing negative size or magazine
Push gripper ridge
42
all the way in the direc-
tion of the arrow “magazine change/turn”
to close the drawslide. Pull magazine straight
towards the rear out of the adapter frame.
To change from horizontal to vertical format
(or vice versa), turn magazine through 90° until
the corresponding yellow format symbol can be
seen at the top.
Insert magazine straight into magazine frame
until it clicks into place. Move gripper ridge
FILM MAGAZINE
42
up. This will open the drawslide, lock the
magazine on the camera and release the shut-
ter button.
Removing the exposed film
After the last frame, the film is automatically
wound up. Open the magazine back and
remove the film insert. Take out the exposed
film and seal it. Replace the film insert and press
the magazine back until it locks.
Note
Before opening the magazine back,
be sure
to
move the gripper ridge in the direction of the
arrow “magazine change/remove insert” as far
as it will go. Failure to do so may damage the
laminar drawslide.
✗
