FRANCO BELGE Savoie 174 08 02 Y, Technical Manual

Page: 5 / 28

•
The flue must not be shared with any other appliance.
•
The chimney must be at least 4.5 m (15 ft high).
•
If the chimney has any downdraught tendency, due to
its position in relation to nearby obstacles, an
anti-downdraught cowl must be installed on the
chimney or the chimney height must be increased.
•
If the chimney draught is excessive or irregular, a
draught stabilizer (barometric damper) must be
installed to the connector pipe.
2.4. Mounting the levelling feet
Figure 5, # 4
Fit the 4 screws and caps supplied on the burner into
each leg of the stove.
2.5. Smoke exit
Figure 5 and 6
The rear exchanger is reversible (2 screws) so that the
smoke exit can be done at rear or on the top
2.6. Chimney connector
•
The appliance must be as close as possible to the
chimney.
•
The connector pipe must be approved for installation
with combustion products (either 24 ga. Black painted
or blued steel or 316 grade 20 ga. Stainless steel or
1 mm vitreous enamelled steel).
•
Pipe diameter must not be less than the appliance
spigot diameter.
•
The join between the connection pipe and the
stovepipe, and the flue, must be leak tight.
•
The connection pipe and any draught stabiliser must
have access for cleaning.
2.7. Levelling
It is essential to ensure that the appliance sits level on
the floor.
-
Use a spirit level across the burner pot to check the
level (fig. 7).
3
1
6
4
4
2
5
Figure 5 - Description
1 - Flue collar
2 - Blanking plate
3 - Draught regulator 4 - Control screws for
appliance leveling
5 - Flue baffle
6 - Burner
Figure 6 - Rear flue outlet
1 - Flue collar 2 - Blanking plate
2
1
Figure 7 - Burner level check
Installation instructions Savoie - ref. 174 08 02 Y
Technical manual "1038" 5