FSW 63
FSW63-14 Multilanguage 01/03/2016
31
GENERAL SAFETY NORMS
When installing or servicing the unit, it is necessary to strictly follow the rules reported on this manual,
to conform to all the specifications of the labels on the unit, and to take any possible precautions of
the case for workers.
Pressure in refrigerant circuit and electrical equipment present in the unit can be hazardous when
installing or servicing the unit
Any intervention on the machine using any instrument must be carried out only
by a qualified technician.
The machine is IPX2 and it must be installed according with local norms and laws
of the place of installation.
Not observing the rules reported on this manual, and every modification to the
unit done without explicit previous authorisation, will cause the immediate
termination of the warranty.
Attention: before every operation of servicing on the unit, be sure that the
electric supply is disconnected.
Never remove front grille or open any part of the
machine without removing first the socket from the plug.
This machine has been designed and manufactured in compliance with the
strictest safety rules. Therefore, pointed instruments (screw drivers, wool
needles or similar ones) are not to be inserted in the grilles or in any other
opening of the panels, especially when it is opened to remove the filter.
Main supply must be protected with a differential switch.
Close to the unit a switched electrical plug must be present, according with
local laws and norms.
Never modify settings of the safety devices.
Never sprinkle water over the unit and its electrical components.
The machine must not be cleaned using water. To clean the machine use a wet
cloth.
Remember to disconnect the plug from the socket before.
When the machine is connected with a power socket, it must be in vertical
position and any rough move must be avoided because it could cause some
water to come into contact with electrical parts; it is, therefore, recommended
to remove the plug from the socket before moving around the machine; if any
water may have been spread on the machine, following some rough handling
of the same, then, the machine must be turned off and can be started up again
only after 8 hours.