FSW63-14 Multilanguage 01/03/2016
38
FSW 63
CONTROL AND SAFETY DEVICES
CONTROL DEVICES
All the control devices are tested on factory before the unit is delivered.
Their operating mode is described in the following paragraphs.
THERMAL PROTECTION DEVICE (only for machines with electric
heaters)
The machine is provided with a safety thermostat which switches off the heaters if the supply air
temperature is too high. In such case the led "Heat" remains on but the heaters does not work and
the air is no longer heated.
In order to reactivate the resistors, the safety device must be reset through the push button which is
located in the black box below the control panel. To access it, disconnect the power supply and, after
removing the cover, unscrew the protective cap with the help of a screwdriver.
INSPECTION, TRANSPORT AND SITE HANDLING
INSPECTION
After receiving the unit, immediately check its integrity. The unit left the factory in perfect condition;
any eventual damage must be questioned to the carrier and recorded on the Delivery Note before it
is signed. Our firm must be informed, within 8 days, of the extent of the damage.
The Customer must prepare a written statement of any severe damage
.
The machine must not be set running in narrow areas, which do not allow a
proper diffusion in the room of the air coming out from the grille. It is, instead,
allowed to set the machine on the sides near the walls.
The front panel should not be used to lay over it cloths or other things: it could
cause damages or dangers.