3D FPV camera The BlackBird 1
User manual
2016
8
2.3
Product use
Camera that is configured and correctly connected starts immediately after power-
up. Led (
see Table 3, position 8
) indicates that power is supplied.
Before long use of the camera, you have to verify the absence of vertical offsets. For
this purpose it is enough to disable the 3D mode on the video receiver and visually to
appraise the offset of the left and right image relative to each other. If there is
noticeable offsets to configure according to
item 3.3
3
Product maintenance
3.1
Setting focus lenses
To adjust the focus you need to do the following actions:
Loosen the fastening screw of one lens (
see table 3, position 5
)
Rotate the lens until the image is clear for the desired distance
Fix the lens with screw
Repeat for the second lens
3.2
Adjusting the vertical offset images
Vertical offset of the image is poorly perceived by human. If there is offset, it`s
possible rapid eye fatigue and incorrect perception of the volume.
To perform the setting you need to prepare the camera for (
see item 2.2
), disable 3D
mode on the receiver of the signal and visually appraise the offset of the left and right
image relative to each other.
Picture 4a shows the image from the adjusted camera, without vertical offset. There
is only horizontal offset caused with the mixing of the optical axis of the lens
(convergence).
Picture 4b shows the image which is not properly configured camera. There is only
the vertical offset.
For correction of offset loosen the screws of the holders of the lens (
see picture 1b,
position 9
), move them to reduce offset images and fix it again. After fixing to appraise
the offset of the image again. If it is necessary, adjust the focusing of the lens.
When you spread boards of camera using the connection cable also need to
remove the vertical offset by turning and safe fixing the boards.
Picture 4. Image offset
a
b
