FPV3DCAM BlackBird 1, User Manual

Page: 10 / 10

3D FPV camera The BlackBird 1
User manual
2016 fpv3dcam.com
9
3.3 Configuring convergence
Convergence is the angle between the optical axis of the lens and the left and right
camera.
If the optical axis of the lens intersect on a monitored object, in this place will be
missing the horizontal offset of the image. The object will be visible on the screen plane.
If the optical axis of the lens intersect behind the object, it will be visible in front of
the screen, and if before the object - behind the screen.
To configure the convergence it is necessary to tilt the lens to each other or apart.
There are no special instruments of fixation of convergence on the product. For fixing it
is necessary to firmly secure the cards of camera during installation.
3.4 Possible errors and methods of their elimination
errors reason elimination
LED doesn`t light
 It is not powered on the
board of camera
 LED is broken.
 Check the power
connection, eliminate
breakage
 Contact technical
support
LED burns, no picture
 Video signal isn't fed to
the receiver
 Malfunction in the
camera's
 Check the power
connection, eliminate
breakage
 Contact technical
support
The image is visible
from only one camera
(half or full), image
jerks
 There is no connection
between boards

The break in
connection cable
 Malfunction in the
camera's
 Check the plug
connection between
boards
 Replace connection
cable
 Contact technical
support
The consumption is
more 150 mA.
 Short circuit in board-
to-board connector
 Short circuit in the
interface cable
 Malfunction in the
camera's
 Check the plug
connection between
boards
 Replace the interface
cable
 Contact technical
support