10
TECHNICAL DATA
DE309
VOLTAGE-FREQUENCY
127 V ~ 60 Hz
NO LOAD SPEED
12 500 r/min
CUTTING CAPACITY
9
"
(22 cm)
NYLON DIAMETER
1,2 mm
POWER CONSUMPTION
250 W
POWER
0,25 kWh
WEIGHT
1,3 kg (2,9 lb)
ASSEMBLY INSTRUCTIONS
ADJUSTMENT OF THE GUARD AND CUTTING
GUIDE
1. Assemble the protective cover.
a) Hold the machine shelf, fitting the protective
cover in the machine shelf.
b) Align the protective cover and the machine
shelf together with the screw.
2. Assemble main handle and middle tube; In-
sert two parts together, fix two parts by the
screw.
3. Assemble motor housing and middle tube;
Insert two parts together, fix two parts by the
screw.
4. Assemble auxiliary handle.
OPERATION INSTRUCTIONS
OPERATION OF THE TRIMMER
NOTE: Remove the blade guard before starting
operation.
1. To turn the trimmer ON press the trigger
switch. To turn OFF, just release the trigger.
2. Let it run for a few seconds without touch-
ing the work area, allow the machine to cut the
nylon to the correct length.
3. When operating the
trimmer hold it at an an-
gle of about 20 degrees
above ground level (Fig.
1). Swing the trimmer
from side to side to make
an even cut (Fig. 2).
HEADCUT
The head of the trimmer is set an angled posi-
tion adjusting to the cutting area.
Press the button showed in Fig. 3 to set and
angle.
DURING OPERATION
Do not overload the
trimmer, cut small sec-
tions to improve cut-
ting efficiency, keep it
running at high speed.
(Fig. 4) .
Use the edge of the guard as a guide when cut-
ting close to fences or walls, etc. Moving back
toward edger prevent damage.
NYLON FEEDING
This electric trimmer
is equipped with an
automatic feeding sys-
tem thread, which is
activated automatically
when you turn off the
trimmer and on again.
REPLACING THE NYLON
1. Firmly press the release buttons on the cover
of the reel.
2. Remove the reel cover, remove the reel and
the old nylon line.
3. Attach the nylon on the reel (arrow in Fig.6)
and wrap it carefully.
4. Follow the same procedure in step 3 to place
the nylon on the opposite side.
NOTE: Wrap both sides and let out enough ny-
lon to easily slip them into the holes on the reel
(Fig. 7).
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
a
b
Fig. 6
Fig. 7
