35
Foxwell OS100 Digital Oscilloscope User’s Guide_English Version_V1.00
Connect a signal to the CH1 input:
1. Connect a signal to the oscilloscope as described above.
2. Click the
“Acquire -> Autoset”
button.
The oscilloscope will change the current settings to display this signal.
Save Setup
The oscilloscope software saves the current setup before you close the oscilloscope software.
The oscilloscope recalls this setup the next time you run the software. You can use the
“Save
Setup”
menu to permanently save up to several different setups.
Load Setup
The oscilloscope can recall the last setup before the oscilloscope software was running, any
saved setups, or the factory setup. You can use the
“Load Setup”
menu to permanently recall a
setup.
Factory Setup
The oscilloscope software is set up for normal operation when it is shipped from the factory. This
is the factory setup. To recall this setup, push the
“Factory Setup”
menu.
3.2 Set Vertical System
Set Channel
Click
“Vertical”
in
“Setup”
menu.
The Channel Selection
The Channel Control Panel in sidebar
The Vertical function:
Turn ON/Off:
Turn on/off the channel
