1. 准备一个 6 Pin 连接线（如下图所示）与 Pixhawk v3 连接。
Prepare a 6 pin wire for the connection use with Pixhawk v3.
2. 检查雷达连接线针脚（如下图）
Check the radar connection wire(as shown below).
3. 将 6 Pin 线与雷达连接线焊接，并将接口整理干净，以防短路烧毁设备（如下图）
Solder the 6 Pin wire to the radar wire and clean the interface to prevent short-
circuiting of the device (as shown below).
一、硬件安装与连接
Hardware installation and connection.
4. 将 6 Pin 线插入飞控的 Telem 1/Telem 2/GPS 2 中的任意一个接口
Insert the 6 Pin wire into any one of the flight controller ports: Telem 1/Telem 2/GPS 2.
1
Summary of Contents for Pixhawk V3
Page 1: ...24G Pixhawk V3 2019 04...
