15
7.6 System Start up
·
When the grid connected system is started, the inverter should be turned on first to avoid the current
pulse of the inverter increasing to the battery pack.
·
All installation and operation must comply with local electrical standards.
·
Check all power cables and communication cables carefully.
1.
Turn on the POWER switch
·
Before starting, please dial DIP to the correct position. DIP represents the number of HV2600 in the
system. Please refer to the following table for details:
DIP position
The number of HV2600
0
2
1
3
2
4
3
5
4
6
5
7
6
8
·
Turn on DC switch and press the POWER switch, all the light will light up, and the green and red
LED on the HV2600 module will light up for 1s at the same time, you will hear the sound of closing
and cutting off the relay in BMS BOX to prove that the system works normally.
2.
Module address assignment
If the system is powered on for the first time, BMS will automatically assign the module address of
HV2600 without manual configuration.
8. Commissioning
There are two LED indicators on the front of the battery packs to show its operating status.
For HV2600
For BMS-BOX
- Alarm LED
Green LED
Red LED
Batteries Status
On for 1s
On for 1s
Initial power on
On for 4s
Off
Work
Off
On
Communication lost
On for 4s
On for 4s
Recoverable alarm
Off
On for 4s
Unrecoverable Alarm
BMS-BOX Condition
Green
Red
Error
Off
Flash
Standby
Flash
Off
Charge/Discharge
On
Off
