14
Chapter 2 Installation Instructions
Line in, Line out, Microphone Jacks (for -6 models)
When using a 2-channel sound source, the Line out jack is used to connect to
speaker or headphone; the Line in jack connects to an external CD player,
tape player or other audio device. The Microphone jack is used to connect to
the microphone.
When using a 6-channel sound source, connect the front speaker to the green
audio output; connect the surround sound speaker to the blue audio output;
connect the center speaker/subwoofer to the red Microphone output.
Rear, Line in/side, Line out, Microphone, CEN/LFE (for -8 models)
When using a 8-channel sound source, connect the front speaker to the green
audio output; connect the rear sound speaker to the black audio output; con-
nect the center speaker/subwoofer to the yellow audio output; connect the side
sound speaker to the blue audio output.
10
9
This motherboard includes interfaces for FLOPPY, IDE device, SATA device,
USB device, 1394 device, IR module, CPU fan, system fan, and others.
FLOPPY
This motherboard includes a standard FLOPPY interface, supporting 360 K, 720 K,
1.2 M, 1.44 M, and 2.88 M FDDs.
HDD connectors: PIDE & SIDE
These connectors support the provided UltraDMA133/100/66 IDE hard disk rib-
bon cable. Connect the cable’s blue connector to the primary (recommended)
or secondary IDE connector, then connect the gray connector to the Ultra DMA133/
100/66 slave device (hard disk drive) and the black connector to the Ultra DMA133/
100/66 master device. If you install two hard disks, you must configure the
second drive as a slave device by setting its jumper accordingly. Refer to the
hard disk documentation for the jumper settings.
Attention:
Ribbon cables are directional, therefore, make sure to always con-
nect with the cable on the same side as pin 1 of the PIDE/SIDE or
FLOPPY connector on the motherboard.
Other Connectors
K8S755FXA-manual-V1.1.p65
2005-2-3, 14:33
14