7310D Installation and User’s Guide
Installation
Foxcom Proprietary Information
17
Document No. 93-005-21-A1
3. Installation
The following section details how to setup the 7310D units
4
.
Setting up the 7310D Transmitters and Receivers consists of the following steps:
1. Setting up the transmitter.
2. Connecting the fiberoptic cable.
3. Setting up the receiver.
4. Powering the IFL.
5. Connecting the back panel jumpers.
6. Aligning the fiberoptic cable.
Observe all warnings and cautions mentioned at the beginning of this manual
(page 11). If after set-up you experience problems, refer to Trouble Shooting on page
38.
Figure 6 - Typical Application of a 7310D Satellite Link
4
This section gives instructions on installing the transmitter and receiver in a chassis rackmount. For
instructions on installing standalone units refer to
Appendix II Installing a Standalone
Unit.
