38
Loosen the handwheel
26
and slide the bracket
14
, while aligning the index on the bearing with
its corresponding position on the graduated scale on the work surface. This position
corresponds to the actual distance from the bearing bracket to the blade.
ASSEMBLY OF BASE’S FEET EXTENSIONS (Fig.8A)
The mitre saw is equipped with two extensions of base’s feet that must be fixed in the rear side
of the base with the screws provided. These extensions must be obligatorily assembled in order
to obtain a better steadiness of the machine.
ASSEMBLY OF WORKBENCH’S EXTENSIONS (Fig.1)
The mitre saw is equipped with two extensions
20
(Fig. 1)
that allow to bear big workpieces.
These extensions can be assembled on both sides of the mitre saw, according to the
dimensions of the workpiece.
3.
Place the extension in the holes located on the base of the mitre saw
3 (Fig. 1)
.
4.
Tighten the locking screw to block the extensions.
ASSEMBLY OF MITRE SAW’S HORIZONTAL CLAMP (Fig.3)
5. The
clamp
27 (Fig.3)
can be assembled both on the left and on the right of the blade and
can be adjusted according to the workpiece.
6.
Do not use the mitre saw before locking the workpiece.
7.
Insert the rod of the clamp unit in the hole located on the base of the machine.
To press the workpiece against the workbench, screw the knob until it blocks the piece.
After finishing cutting, loosen the locking knob in order to slide or remove the piece.
14
26
Fig. 8
Fig.8A
