37
ADJUSTMENT OF UPPER SURFACE’S HEIGHT (Fig. 5-6-7-7A)
JUST FOR CIRCULAR SAW
ATTENTION: When working on the upper surface, it is absolutely necessary to install the
lower protective cap 23 supplied.
To install the additional protective cap
23
:
- install the additional protective cap by inserting it into the slot provided
(Fig. 7)
;
- place and then lock the head with the locking pin
16;
- afterwards position and lock the operating head with the locking pin
19.
To adjust the height of the upper work surface in order to obtain desired cutting widths, follow
the instructions below:
- loosen the front lever
25
;
- move the bearing bracket
14
towards the blade;
- adjust and perfectly position the surface without the blade protruding any further than the
height of the tooth from the material to be cut;
- tighten the front lever
25
;
ADJUSTMENT OF THE BEARING BRACKET (Fig. 8)
JUST FOR CIRCULAR SAW
You can draw up or push away the bearing bracket
14
from the blade, in order to cut planks of
pre-established length or width.
23
Fig.5
Fig.6
Fig.7
23
16
25
14
Fig.7A
