18
MOUNTING THE SANDING DISC AND HOUSING
Figure 4
Remove the back sheet of the sanding disc.
Align the perimeter of the sanding disk with the support
plate; firmly apply to ensure it sticks.
Place the housing against the lower 1/3 of the disc;
align the holes as shown in Figure 4.
With two Phillips screws, secure the cover in place.
Always remove the worn disc completely before fitting
a new one.
ASSEMBLING AND REPLACING THE SANDING
BELT
Figure 5
Directional arrows within the band to indicate the direction of
rotation of the sanding belt.
Remove the lower cover plate.
Pull the tension lever to remove the tension on the
sanding belt
Loosen the belt support tilt screws to allow tilting
support
Unscrew the two stop fixing screws and remove the
stop
Remove the tape.
Place the new sanding belt and the driving drum and
the free drum; the arrows should be oriented for movement in a
counterclockwise direction.
Make sure that the sanding belt is centered on both
drums.
Push the tension lever to apply tension on the sanding
belt.
Replace the backstop.
Replace the bottom cover plate and secure it with two
screws.
Reposition the band in a horizontal position.
Tighten the mounting screws.
Note: The tensioning lever is tensioned by a spring; be careful
when applying pressure to avoid injury.
