23. Now fully install the reservoir bracket
onto the vehicle using the supplied
¼"
self-tapping screws.
24. Using two supplied billet clamps
and screws, mount the reservoir to
the brackets. Utilize the slots in the
bracket to locate clamps. Do not feed
the clamps through the slots in the
brackets. (Figure 11)
25. Installed coil-over will resemble
Figure 12.
26. If equipped, reinstall skid plate, torque
to OEM specifications.
27. Check that the suspension has proper
clearance by steering completely in
both directions.
28. Reinstall front wheels and torque to
OEM specifications.
Figure 11: Passenger side bracket shown
Figure 12: Driver Side Shown, (Left: 2.5 Factory Race
Series Shock, Right: 2.0 Performance Series IFP Shock)
29. Set vehicle back on the ground and
drive it back and forth several feet
to allow the suspension to settle.
Now measure ride height and make
adjustments if necessary. READ
INSTALLATION GUIDELINES ON HOW
TO PROPERLY ADJUST PRELOAD.
(See page 2 of this instruction manual)
30. It is highly recommended that you
have your wheel alignment checked.
1.800.FOX.SHOX (369.7469) 619.768.1800 [email protected]
7