December 2008
© 2008 Foundry Networks, Inc.
3-1
Chapter 3
Installing a NetIron MLX Series Router
This chapter contains information on how to install a NetIron MLX Series router. Before proceeding, please read
the cautions and warnings below that apply to the entire family of NetIron MLX Series routers.
The remainder of this chapter contains the following topics:
•
“Installing a NetIron MLX-4 Router”
•
“Installing a NetIron MLX-8 Router”
•
“Installing a NetIron MLX-16 Router”
•
“Installing a NetIron MLX-32 Router”
WARNING:
The procedures in this manual are for qualified service personnel.
WARNING:
If the installation requires a different power cord than the one supplied with the device, make sure
you use a power cord displaying the mark of the safety agency that defines the regulations for power cords in your
country. The mark is your assurance that the power cord can be used safely with the device.
Installation Precautions
Follow these precautions when installing a NetIron MLX Series router.
General Precautions
WARNING:
All fiber-optic interfaces use Class 1 Lasers.
CAUTION:
Do not install the device in an environment where the operating ambient temperature might exceed
40o C (104o F).
CAUTION:
Make sure the air flow around the front, sides, and back of the device is not restricted.
CAUTION:
If you do not install a module in a slot, you must keep the slot blank in place. If you run the chassis
with an uncovered slot, the system may overheat.
CAUTION:
Never leave tools inside the chassis.
