Forza FDC-1001RUL, User Manual

Page: 2 / 8

Table of content
1. Introduction
1-1 Transportation
1-2 Preliminary steps
1-3 Initial setup
1-4 Important safety instructions
1-5 Maintenance, service and faults
2. Operation
2.1 Unpacking and inspection
2.2 UPS diagram
2.3 Installation procedure
2.4 UPS connections
2.5 Enable/disable ROO and RPO function
2.6 Turning on/off the UPS
2.7 ForzaTracker monitoring software
3. Advanced operation
3.1 Description of buttons and functions
3.2 LED panel
3.3 Audible alarm
4. Troubleshooting
5. Storage and maintenance
6. Technical specifications
1. Introduction
Thank you for purchasing the Forza FDC-1001RUL and FDC -1002R-I Online UPS. To enjoy all the features and benefits of this unit,
please read and follow all installation and operation instructions thoroughly before unpacking, installing or operating this device. After
you have read this manual, keep it in a safe place for future reference.
The information contained in this manual covers the 1000VA uninterruptible power system, its basic functions, operating procedures,
options available and troubleshooting guide. It also includes information on how to ship, store, handle, and install the equipment.
1-1. Transportation
• Make sure to transport the UPS system only in the original package to protect it against shock and impact.
1-2. Preliminary steps
• Water condensation may occur if the UPS is unpacked in a very cold environment and then moved to a warmer location.
• The UPS must be thoroughly dry before being installed. Failure to do so may increase the risk of electric shock.
• Do not install the UPS system near water or in moist environments.
• Do not install the UPS system where it would be exposed to direct sunlight or near a heater or heating vent.
• Do not block ventilation holes in the UPS housing.
1-3. Initial setup
• Do not connect appliances or equipment that may overload the UPS system (such as a laser printer) to the output sockets.
• Place cables in such a way that no one can step on or trip over them.
• Do not connect domestic appliances, such as hair dryers, to the UPS output sockets.
• Connect the UPS system only to an earthed shockproof outlet which must be easily accessible and close to the UPS system.
• Please only use certified electrical cables for input and output connections.
• During the installation of this equipment, make sure that the sum of the leakage currents of the UPS and the connected loads shall
not exceed 3.5 mA.
1-4. Important safety instructions
• Do not disconnect the mains cable on the UPS system or the building wiring outlet (shockproof socket outlet) at any time, since this
would cancel the protective earth of the UPS system and of all connected loads.
• Connect the UPS only to a grounded socket that meets electrical safety guidelines.
• Locate the UPS near a wall socket. Do not use an extension cord between the UPS and the socket.
• In the event of an emergency, press the Power button and disconnect the power cord from the AC mains to properly disable the
UPS.
• Do not allow any kind of liquid or foreign object to enter this UPS unit. Do not place beverages or any other containers
with liquid on or nearby the unit.
• The UPS can be operated by any individual with no previous experience.
• AC output power cords (not supplied with the unit) should be chosen to support maximum output current per outlet of 13A.
A5-15P (13A, 125V) plug is recommended. A cable of at least 16AWG and 120V is recommended.