2
INSTALLATION INSTRUCTION
Please contact the authorized service agent for installation of the appliance. To make the appliance ready for use,
review the user manual and make sure that the electricity, tap water supply and water drainage systems are
appropriate before calling the authorized service agent. Otherwise, call a qualified technician and plumber to
have any necessary arrangements carried out.
Preparation of the location and electrical, tap water and waste water installations at the place of
installation is under customer's responsibility.
Make sure that the water supply hoses and water draining houses as well as the power cord are not
folded, pinched or crushed while pushing the appliance into its place after installation or cleaning
procedures.
Warning: Installation and electrical connections of the appliance must be carried out by the authorized
service agent. Manufacturer shall not be held liable for damages that may arise from procedures
carried out by unauthorized persons.
Warning: Prior to installation, visually check if the appliance has any defects on it. If so, do not have
it installed. Damaged appliances cause risks for safety.
Appropriate installation location
Place the appliance on a rigid floor. Do not place it on a long pile rug or similar surfaces.
Total weight of the washing machine and the dryer with full load when they are placed on top of each other
reaches approximate 180 kilograms. Place the appliance on a solid and flat floor that has sufficient load
carrying capacity!
Do not place the appliance on the power cord.
Do not install the appliance at places where temperature may fall below 0ºC.
Place the appliance at least 1 cm away from the edges of other furniture.
Removing packaging reinforcement
Tilt the washer backwards to remove the packaging reinforcement. Remove the packaging reinforcement by
pulling the ribbon.
Removing the transportation locks
Warning: Do not remove the transportation locks before taking out the packaging reinforcement.
Warning: Remove the transportation safety bolts before operating the washing machine! Otherwise,
the appliance will be damaged.
1.
Loosen all the bolts with a suitable spanner
until they rotate freely (C).
2.
Remove transportation safety bolts by turning
them gently.
3.
Attach the plastic covers (packed with the user
manual) into the holes on the rear panel. (P)
Keep the transportation safety bolts in a safe place to reuse when the washing machine needs to be
moved again in the future.
Never move the appliance without the transportation safety bolts properly fixed in place!
