17
Cancelling the programme
Press and hold Start / Pause button for 3 seconds. Start symbol will flash. Programme indicator of the step at
which the programme was cancelled will remain lit. "End" will appear on the display and the programme will be
cancelled.
If you want to open the loading door after you have cancelled the programme but it is not possible to
open the loading door since the water level in the appliance is above the loading door opening, turn the
Programme Selection knob to Spin+Drain programme and discharge the water in the washer.
End of programme
“End” will appear on the display at the end of the programme. Programme indicator of the programme steps will
remain lit. Auxiliary function, spin speed and temperature that were selected at the beginning of the programme
will remain selected.
The appliance is equipped with a “Standby Mode”
If not starting any programme or waiting without making any other operations when the washer is turned on by
On/Off button and while it is in selection step or if no other operations are performed in approximately 2
minutes after the selected programme has come to an end, the washer will automatically switch to energy saving
mode. Brightness of indicator lights will decrease. Also, if the appliance is equipped with a display showing the
programme duration, this display will completely turn off. When rotating the Programme Selection knob or
pressing any buttons, lights and display will restore to their previous condition. The selections made while
exiting the energy saving mode may change. Check the appropriateness of the selections before starting the
programme. Read just if necessary. This is not a fault.
MAINTENANCE INSTRUCTION
Service life of the appliance extends and frequently faced problems decrease if cleaned at regular intervals.
Cleaning the detergent drawer
Clean the detergent drawer at regular intervals (every 4-5 washing cycles) as shown below in order to prevent
accumulation of powder detergent in time.
1.
Press the dotted point on the siphon in the softener compartment and pull towards until the compartment is
removed from the washer.
If more than normal amount of water and softener mixture starts to gather in the softener compartment,
the siphon must be cleaned.
2.
Wash the detergent drawer and the siphon with plenty of lukewarm water in a washbasin. Wear protective
gloves or use an appropriate brush to avoid touching the residues in the drawer with the skin when cleaning.
3.
Insert the drawer back into its place after cleaning and make sure that it is seated well.
If your detergent drawer is the one indicated in the following figure:
Lift the rear part of the siphon to remove it as illustrated. After performing the above mentioned
cleaning procedures, replace the siphon back to its seating and push its front section downwards to
make sure that the locking tab engages.
