PILOT
PILOT
PILOT ADJUSTMENT
PILOT
PILOT
PILOT ADJUSTMENT
800•722•6075
Warranty/Tech Support
Service, Installation
& Care Manual
18
COUNTERTOP GRIDDLE MANUAL GAS
COUNTERTOP RADIANT GAS CHARBROILER
1. Open the manual gas supply valve (which will
release gas into the equipment).
2. Put your lighting device (wick) past the ignition
hole in the flame of the pilot on the equipment
panel until contact with the pilot burner and until
the flame ignites, repeat this procedure on all
pilots (see following image).
*Note: The ignition order does not interfere with
the use of the equipment.
3. Turn the knob corresponding to the burner you
wish to operate counterclockwise (adjust the
flame through the knob).
4. Make sure the burner is lit. If the burner does not
light, repeat the procedure.
5. After lighting all burners, you can turn off the
burners and turn them back on simply by turning
the corresponding knobs.
*Note:Thepilotburnerflameisfactoryset
according to the gas for which the equipment
was originally manufactured. Always check
throughtheholeidentifiedonthepanelas
PILOT,ifthepilotburnerflameislit.Ifitisnot,
perform the procedures described above again.
1. Open the manual gas supply valve (which will
release gas into the equipment).
2. Put your lighting device (wick) past the ignition
hole in the flame of the pilot on the equipment
panel until contact with the pilot burner and until
the flame ignites, repeat this procedure on all
pilots (see following image).
3. Rotate the knob corresponding to the burner you
wish to operate, rotate 90° counterclockwise.
4. Make sure the burner is lit. If the burner does not
light, repeat the procedure.
5. After lighting all burners, you can turn off the
burners and turn them back on simply by turning
the corresponding knobs.
*Note:Thepilotburnerflameisfactoryset
according to the gas for which the equipment
was originally manufactured. Always check
throughtheholeidentifiedonthepanelas
PILOT,ifthepilotburnerflameislit.Ifitisnot,
perform the procedures described above again.
02. EQUIPMENT INSTALLATION