1.3 Operation Introduction
1.3.1 Power on again
User may switch to the offline write mode after they have finished task of online
download, the detailed steps are shown as the below:
first plug out
USB
data line to make device power off
then make the switch to
Offline
on the left of the Writer (refer to chapter
1.2.3)
then re-connect
USB
data line to the write hardware board, and power on the
device again via
USB
.
According to the above three steps, device will enter the offline write mode, the
boot screen is shown as the below:
Chart 1-3-1
1.3.2 Offline Write Mode
Offline write steps:
Before power on agagin, make sure both
SW1
and
SW2
are switched to
Low
, but
SW3
should keep
High
Power on, entry into the
Offline Write
mode
Put the
IC
of FU68xx series into
Socket
, and make sure it is in good contact
Press the yellow or
Blue
key on the board, and the device will execute the
corresponding action
Rev_V1.8 9 / 20
www.fortiortech.com
