Fortior Tech FU68 Series, User Manual

Page: 12 / 20

should keep High ; Or in Write Mode,switch SW2 and SW3 to High , then enter
Verify Mode

Power on,enter the CRC Verify Mode

Put the IC of FU68xx series into Socket ,and make sure it is in good contact

Observe the device doing task status on the LCD panel
Chart
1-3-3
1.3.4 Erase Mode
Erase steps
：

Before power on again,make sure SW1 and SW3 both are switched to Low ,but
SW2 should keep High ; Or in Write Mode,switch SW2 to Low , and switch SW3
to High , then enter Erase Mode

Power on,enter Erase Mode

Put the IC of FU68xx series into Socket ,and make sure it is in good contact

Observe the device doing task status on the LCD panel
Chart
1-3-4
Rev_V1.8 12 / 20 www.fortiortech.com