48
01-28008-0030-20050128
Fortinet Inc.
Connecting the FortiGate unit to the network(s)
NAT/Route mode installation
Starting the setup wizard
1
In the web-based manager, select Easy Setup Wizard.
Figure 13: Select the Easy Setup Wizard
2
Follow the instructions on the wizard pages and use the information that you gathered
in
Table 7 on page 42
and
Table 9 on page 47
to fill in the wizard fields.
3
Select the Next button to step through the wizard pages.
4
Confirm the configuration settings, and then select Finish and Close.
You are now finished the initial configuration of the FortiGate unit.
Connecting the FortiGate unit to the network(s)
When you have completed the initial configuration, you can connect the FortiGate unit
between your internal network and the Internet.
Antivirus
High
Create a protection profile that enables virus
scanning, file blocking, and blocking of oversize
email for HTTP, FTP, IMAP, POP3, and SMTP. Add
this protection profile to a default firewall policy.
Medium
Create a protection profile that enables virus
scanning, for HTTP, FTP, IMAP, POP3, and SMTP
(recommended). Add this protection profile to a
default firewall policy.
None
Do not configure antivirus protection.
Select one of these security levels to protect your network from viruses.
Table 9: Setup wizard settings
Note:
If you change the IP address of the interface you are connecting to, you must connect
through a web browser again using the new address. Browse to https:// followed by the new IP
address of the interface. If the new IP address of the interface is on a different subnet, you may
have to change the IP address of your computer to the same subnet.
Note:
If you use the setup wizard to configure internal server settings, the FortiGate unit adds
port forwarding virtual IPs and firewall policies for each server. For each server located on your
internal network the FortiGate unit adds a WAN1
->
Internal firewall policy.